Starting from vSphere 4.1, IPv6 support has been introduced to the virtual platform from VMware. It is enabled in the vCenter Server Appliance by default and can be controlled in VCSA 6.0 and 6.5 from the Direct Console User Interface (Customize System > Configure Management Network > IPv6 Configuration).
To my surprise, disabling IPv6 can cause some problems with the VCSA updates. I will explain this statement and provide a workaround in the paragraphs below.
Imagine your security team requires IPv6 to be turned off on vCenter Server. Following this call, you proceeded with the configuration change in DCUI.
After rebooting the virtual machine, it all should work fine. Now, it is time to update the virtual appliance to a newer version. You downloaded a patch file, attached it to the VM, and started the update process from the VMware vSphere Appliance Management Interface.
When the server reboots, you will notice the Appliance Management User Interface is not accessible anymore. To troubleshoot this issue further, we need to open SSH session with the appliance and enable Shell mode.
Firstly, we need to netstat command to see if any service is listening on TCP port 5480. The command output does not show anything.
The next step is to identify the service which provides the Appliance MUI and its current status. Fortunately, I have noticed an error message which is related to the problem when the operating system is booting up.
Querying the vami-lighttp.service status shows the following results.
So it is a duplicate parameter server.use-ipv6 in the configuration file which was causing this behaviour. To find this file, I was using a combination of rpm and egrep commands to filter the output.
A quick search in /opt/vmware/etc/lighttpd/lighttpd.conf shows that there are two identical lines with IPv6 settings as follows:
To fix this issue, I removed one of the lines, started the vami-lighttp.service and checked that the service works as expected.
To be continued…